Epilog Laser Fusion Maker Manual page 2

17000 - Z-Belt Replacement
Z- Belt Replacement
Z-Belt Removal
1. Turn off the engraver.
2. Disconnect the engraver from power.
3. Remove the right panel of the engraver:
4. Remove the front access panel and the
crumb tray of the engraver:
5. Using a pencil, make a mark on the
engraver chassis that corresponds with
the leading edge of the z-axis motor
bracket. This will help to ensure the
correct z-axis belt tension is applied
when the new z-axis motor is installed:
6. Disconnect the z-axis motor electrical
harness.
7. Loosen, but do not remove the z-axis
motor tensioner thumbscrew to release
the tension on the z-axis belt:
2