Epilog Laser Fusion Maker Manual page 4

17000 - CO2 Laser Tube Replacement
3. Tighten the three (3) green-capped
Phillips captive screws on the laser
tube mounting brackets. There is one
(1) on the left bracket and two (2) on
the right bracket:
4. Connect the laser tube power harness
from the main electrical harness of the
engraver.
5. Connect the data cable on the left
side of the laser tube:
6. Reconnect to power and turn on the
engraver.
After a CO2 laser tube replacement you
must complete the laser alignment and
all focus calibrations.
If further assistance is required, please
contact Epilog Laser Technical Support
by phone at 303-215-9171, or by email at
tech@epiloglaser.com.
4