Epilog Laser Fusion Maker Manual page 3

17000 - CO2 Laser Tube Replacement
The green-capped screws are captive
screws and cannot be fully removed from
the laser tube mounting brackets. When
the screws have been fully loosened, they
will pop away from the laser tube mount-
ing bracket.
8. Slide the laser tube towards the left to
clear the guide pin that holds the laser
tube in place:
9. Remove the laser tube from the
engraver:
CO2 Laser Tube Installation
1. Install the laser tube into the laser bay,
ensuring that the guide pin on the
engraver chassis enters the opening on
the left bracket:
2. Slide the laser tube towards the right
to engage the guide pin that holds the
laser tube in place:
3