Epilog Laser Fusion Maker Assembly Replacement page 4

17000 - Z-Axis PCB Replacement
4. Lift the z-axis PCB until the top edge
of the board is aligned with the
pencil mark created in the removal
procedure:
5. Tighten the four (4) 5/16 nuts that
secure the z-axis PCB to the chassis of
the engraver:
6. Connect the communication cable to
the z-axis PCB:
7. Replace the right panel of the
engraver:
After replacing the z-axis PCB, complete
the table calibration, CO2 and or fiber
focus, and autofocus calibrations.
If further assistance is required, please
contact Epilog Laser Technical Support
by phone at 303-215-9171, or by email at
tech@epiloglaser.com
4