Epilog Laser Fusion Maker Assembly Replacement page 3

17000 - Z-Axis PCB Replacement
7. Loosen and remove the four (4) 5/16
nuts that secure the z-axis PCB to the
engraver chassis:
8. Remove the z-axis PCB from the
engraver:
Z-Axis PCB Installation
1. Place the anti-static strap around
your wrist and attach the clamp to a
bare metal surface on the engraver.
!
2. Place the z-axis PCB over the
mounting studs:
3. Install, but do not fully tighten the four
(4) 5/16 nuts that secure the z-axis PCB
to the chassis of the engraver:
3