Advertisement
Updated "Overrange" warning to "Excessive Ingress"
▪
Prior to 3.16 firmware, if the tech had too
much noise detected on Port 2 of the ONX
during a OneCheck Ingress test, the tech
would have been shown a message stating
"OVERRANGE"
▪
This Overrange warning may not have been
clear to the tech that more than the
measurable amount of power has been
detected, causing a failure, and that further
Ingress troubleshooting should be performed
▪
As of 3.16 we have updated that message to
say "EXCESSIVE INGRESS" and have
colored the background red, reinforcing that
this is a failure due to the detection of too
much ingress at this test location
As of 3.16
Prior to 3.16
viavisolutions.com
© 2020 VIAVI Solutions Inc.
97
Advertisement
