8. Initialization Method
This document explains the setting procedure from the factory default setting.
If the device settings are changed from the factory default setting, some settings may not be
applicable as described in this procedure.
8.1. Initializing the PLC
To initialize the PLC, it is necessary to initialize the Ethernet Unit and the CPU Unit. Place in
the PROGRAM Mode before initialization.
8.1.1.
Ethernet Unit
To initialize the settings of the Ethernet Unit, select Edit – I/O Table from the PLC Menu of the
CX-Programmer.
On the PLC IO Table Dialog Box, right-click the Ethernet Unit and select Unit Setup from the
menu that is displayed.
On the Edit Parameters Dialog Box, click the Set Defaults Button, and click the Transfer (PC
to Unit) Button.
8.Initialization Method
32