Abb Flextronics - ABB Busch E-contact System Manual

Table of Contents

3.5.2

ABB flexTronics

Fig. 12: Display of operating status

The operating status of the devices is displayed by means of a red LED at the front of the

device.

Devices with IR reception

Operating status

Test mode

Continuous light operation

Continuous OFF operation

Manual mode

Automatic mode

IR reception

Table 20:Operating status: Busch-Presence detector flex sensors

System Manual 2CKA001473B9577

LED

Flashes at a detected movement, the connected load switches

■

on for approx. 5 seconds.

In test mode the switch-off delay amounts to 5 seconds, the

■

brightness value is set on daylight.

Switch the test mode by setting the desired brightness value on

■

the trimmer or by pressing the desired switch-off delay on the IR

remote control (not possible with 64754-xxx)

Notice

Due to the high sensitivity in the internal detection range (directly

below the device), the pacing of the detection range is only possible

with a distance of more than 2 metres from the device. If you are

within this detection range, the device will always detect movement

and not switch off.

Continuous ON

OFF

Flashes fast

Device Functions

│52

Table of Contents