ABB Busch E-contact System Manual page 103

The basic lighting can be activated using the "ABB Watchdog Remote control" smartphone app.
The starting and ending times and brightness value of the basic lighting can also be set using
the app.
Notice
When determining the luminosities and setting of the device, pay attention to the
different brightness distributions in the room.
Depending on the reflection conditions in the room or at the workstation, a
considerably lower brightness value is determined at the mounting site of the
device. If it should be switched on, for example, when the brightness at the
workstations drops below 500 lux, you must set a value of about 100 lux on the
device.
The "Take-over of current brightness" app function indicates the current
brightness at the mounting site. This value can be take over directly for
simplified commissioning.
Notice
When making the setting, pay attention to the legal requirements for luminosities
at workstations.
Examples of switching
16A
L
N
Fig. 59: Examples of switching: DALI light control system with extension unit input and basic lighting in a larger office
[1] Universal BT, DALI
[2] When using voltage enabling of DALI operating devices.
[3] Universal, DALI extension unit
[4] Universal, DALI extension unit
[5] DALI operating device
[6] Extension unit push-button (e.g. for detection enabling in semi-automatic mode)
System Manual 2CKA001473B9577
Information about planning and application
6
1 2 3 4 5
│103