Related Manuals for ABB Eden
Summary of Contents for ABB Eden
- Page 1 Please note! This model of Eden is obsolete and has been replaced by Eden DYN Original instructions Eden Non-contact safety sensor ABB Jokab Safety Varlabergsvägen 11, SE-434 39 Kungsbacka, Sweden www.abb.com/jokabsafety...
-
Page 2: Read And Understand This Document
DAMAGES, LOSS OF PROFITS OR COMMERCIAL LOSS IN ANY WAY CONNECTED WITH THE PRODUCTS, WHETHER SUCH CLAIM IS BASED ON CONTRACT, WARRANTY, NEGLIGENCE, OR STRICT LIABILITY. In no event shall responsibility of ABB JOKAB SAFETY for any act exceed the individual price of the product on which liability asserted. -
Page 3: Table Of Contents
Please note! This model of Eden is obsolete and has been replaced by Eden DYN Table of Contents Read and understand this document ........................2 Introduction ............................4 Scope ..................................4 Audience ................................... 4 Prerequisites ................................4 Special notes ................................4 Overview .............................. -
Page 4: Introduction
This model of Eden is obsolete and has been replaced by Eden DYN Introduction Scope The purpose of these instructions is to describe the non-contact safety sensor Eden and to provide the necessary information required for installation and operation. Audience This document is intended for authorized installation personnel. -
Page 5: Overview
E-stops on the same safety circuit. Adam is available with an M12-connector or with an integrated cable of up to 20 m. Eden E is designed for harsh environments and with its protective housing it achieves protection class IP69K (maximum sensing distance for Eden E is 12 mm +/- 2 mm). -
Page 6: Connections
Caution! All cable colours according to ABB Jokab Safety standard cables. Warning! Eden is equipped with an information output able to indicate the status of the sensor. The information channel output is non-safe and should never be used for the safety function. The only signals intended for safety functions are the safe dynamic signals. -
Page 7: Connection Examples
Please note! This model of Eden is obsolete and has been replaced by Eden DYN Connection examples Connection example: Two Eden and one Spot T/R connected to Pluto safety-PLC Caution! All cable colours according to ABB Jokab Safety standard cables. - Page 8 Please note! This model of Eden is obsolete and has been replaced by Eden DYN Connection example: Different sensors connected to Vital 1 safety module Caution! All cable colours according to ABB Jokab Safety standard cables. 2TLJ172066M0201, rev. F www.abb.com/jokabsafety...
-
Page 9: Installation And Maintenance
Eva can be turned in a number of different ways relative Adam, see details in the figure below. Depending on the cable connector used to connect to Eden, different distance plates can be necessary in order to avoid damage to Adam. -
Page 10: Installation Precautions
Please note! This model of Eden is obsolete and has been replaced by Eden DYN Cable mounting The cable should be mounted so there is no force on Adam sensor in any directions. The cable should be fixed if it’s connected to a moving object, for example a cable chain or a door. This can be done with for example two cable clamps. -
Page 11: Maintenance
(EN 62061:2005). In case of breakdown or damage to the product, contact the nearest ABB Jokab Safety Service Office or reseller. Do not try to repair the product yourself since it may accidentally cause permanent damage to the product, impairing the safety of the device which in turn could lead to serious injury to personnel. -
Page 12: Operation
Please note! This model of Eden is obsolete and has been replaced by Eden DYN Operation LED indication Operation status LED Indication Description Green Eva close, safety circuit closed Green-Red (flash) Eva close, safety circuit broken by a previous unit... -
Page 13: Model Overview
Protective housing for (5-pole, male) extreme surroundings (IP69K) Cable length: 3 / 10 / 20 m * Some Eden models are available in grey; refer to your ABB Jokab Safety sales representative for more information. Accessories Type Article number Description 2TLA020053R0000... -
Page 14: Technical Data
Please note! This model of Eden is obsolete and has been replaced by Eden DYN Technical data Manufacturer Address ABB JOKAB SAFETY Varlabergsvägen 11 SE-434 39 Kungsbacka Sweden Power supply Operating voltage 24 VDC +15 %, -25 % Total current consumption... - Page 15 Performance level: Pl e, category 4 Certificates TÜV Nord The Jokab Safety branded product with article number beginning with 2TLJ is fully compatible with the ABB branded product with article number beginning with 2TLA. Intended use NB! These restrictions are only according to certification for CSA (Canada/USA).
- Page 16 Please note! This model of Eden is obsolete and has been replaced by Eden DYN Eden E dimensions NB: All measurements in millimetres. 2TLJ172066M0201, rev. F www.abb.com/jokabsafety 2015-02-09...
-
Page 17: Ec Declaration Of Conformity
Please note! This model of Eden is obsolete and has been replaced by Eden DYN EC Declaration of conformity ABB JOKAB SAFETY Varlabergsvägen 11, SE-434 39 Kungsbacka, Sweden www.abb.com/jokabsafety 2TLJ172066M0201, rev. F www.abb.com/jokabsafety 2015-02-09...