ABB Busch E-contact System Manual page 35

Table of Contents

Trimmer setting blockage (only Monoblock devices)

–

The setting of the device can be blocked by the trimmer through the app. Three setting

variants are possible:

Trimmer blocked:

■

The values can be set only via the app.

Limited access:

■

Activation takes place via the app. After that, the password can no longer be bypassed

by the disconnection of the presence detector. Reactivation is possible only via the

following trimmer setting:

–

In the first 2 minutes after activation, set the trimmer for the brightness-value

threshold to "Sun" and the trimmer for the operation mode to "Automatic with 30-

minute switch-off delay".

Within these first 2 minutes, the app can access the presence detector without a

password.

Trimmer active:

■

The settings can be made through the trimmer and app. In general, the last setting

(trimmer or app) is always used.

–

Password forgotten/reset password:

–

If the device password is no longer known, it can be reset using the "Reset to factory

setting" app function. No device password is set in the factory setting.

ATTENTION!

All individual device settings and saved "Energy Monitor" data are also lost.

System Manual 2CKA001473B9577

time

Lux

min

2.000

300

1.000

Device Functions

│35

Table of Contents