Control Panel - Supermicro A+ Server AS -1015SV-WTNRT User Manual

Control Panel

Unit LED Button
Information LED
LAN2 LED
LAN1 LED
Feature Description
Push this button to turn on the blue UID LED indicators both at the front and at the rear.
UID LED Button This helps in identifying the unit when requiring service, especially when it is part of a large
installation. The BMC can be reset using the UID switch
Information LED Alerts operator to several states, as noted in the table below.
LAN2 LED Indicates network activity on LAN port 2 when flashing.
LAN1 LED Indicates network activity on LAN port 1 when flashing.
Storage Drive LED Indicates activity on the storage drives when flashing.
Steady on – Power on
Blinking at 4 Hz – Checking BIOS/BMC integrity
Power LED Blinking at 4 Hz and "i" LED is blue – BIOS firmware updating
Two blinks at 4 Hz, one pause 2hz and "i" LED blue – BMC firmware updating
Blinking at 1 Hz and "i" LED red – Fault detected
Reset Button Reboot the system
The main power switch applies or removes primary power from the power supply to the
Power Button
server but maintains standby power. Hold for four seconds to force a shut-down.
Color, Status
Red, solid
Red, blinking at 1 Hz
Red, blinking at 0.25 Hz
Red, solid, with Power LED blinking green
Blue and red, blinking at 10 Hz
Blue, solid
Blue, blinking at 1 Hz
Blue, blinking at 2 Hz
Blue, blinking at 4 Hz
Blue, blinking at 10 Hz with Power LED blinking green BMC/BIOS firmware is updating
Figure 1-2. Control Panel
Control Panel Features
Information LED
Description
An overheat condition has occurred.
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power supply.
Fault detected
Recovery mode
UID has been activated locally to locate the server in a
rack environment.
UID has been activated using the BMC to locate the
server in a rack environment.
BMC is resetting
BMC is setting factory defaults
12
Chapter 1: Introduction
Power
Reset
Power LED
Storage Drive LED