Control Panel - Supermicro AS -1015CS-TNR-EU User Manual

Control Panel

UID button
Information LED
Features Description
The unit identification (UID) button turns on or off the blue light function of the Information
UID button LED and a blue LED on the rear of the chassis.
(& BMC Reset) This button can also be used to
the front VGA port, if available.
Information LED Alerts operator to several states, noted in the table below.
Indicates network activity on LANs when flashing; defaults to the first two ports of the CPU1
NIC LEDs
AIOM.
HDD LED Indicates activity on the hard drive when flashing.
Steady on – Power on
Blinking at 4Hz – Checking BIOS/BMC integrity
Power LED Blinking at 4Hz and "i" LED is blue – BIOS firmware updating
Two blinks at 4Hz, one pause 2hz and "i" LED blue – BMC firmware updating
Blinking at 1Hz and "i" LED red – Fault detected
Reset Button Reboots the system.
The main power switch applies or removes primary power from the power supply to the
Power Button
server but maintains standby power.
Power LED
NIC LEDs
HDD LED
Figure 1-2. Control Panel
Control Panel Features
reset the BMC
11
Chapter 1: Introduction
Power button
Reset button
and will disable the rear VGA port to enable