Supermicro A+ Server AS -1015SV-WTNRT User Manual page 59

Chapter 4: Motherboard Connections
1. COM Port
There is one serial communications port (COM1) on the rear I/O panel.
2. IPMI LAN Port
One IPMI LAN port is located on the I/O back panel. This port accepts an RJ45 type cable.
3~6. Universal Serial Bus (USB) Ports
There are four USB 3.0 ports (USB 0/1, 2/3) on the I/O back panel. These support the type
A connector.
7~8. LAN Ports
There are two LAN ports located on the I/O back panel (LAN1 & LAN2). These ports accept
RJ45 type cables.
9. VGA Port
There is one VGA port on the rear I/O panel.
10. UID Switch and UID LED Indicator
A Unit Identifier (UID SW) switch and UID LED (LED1) are located on the I/O backpanel. The
rear UID LED (LED1) is located next to the UID switch. When you press the UID switch, both
rear and front UID LED indicators will turn on. Press the UID switch again to turn off the LED
indicators. The UID Indicator provides easy identification of a system that may be in need
of service. See 2.6 Front Control Panel for the front panel UID LED header location on JF1.
Note: UID can also be triggered via IPMI on the motherboard. For more information on IPMI,
please refer to the IPMI User's Guide posted on our website at http://www.supermicro.com
59