Telecom Behnke Hybrid Series Instructions Manual page 87

Instructions for Behnke Hybrid series 20-0005-BS, SIP intercoms series 20-0005B-IP
Then enter a 2-digit speed dial between 00 and 99.
When entering call numbers, the same special symbols are allowed as for a call number for a direct
call button.
Network Configuration Mode
70 0 # end
1 # start
If the network configuration is incorrect, network access may no longer be possible. In this case, you
can regain access to the device as follows. Start the network configuration mode by entering config-
uration step 70 1#. The device then behaves with regard to the network configuration as per delivery
state. It therefore either receives an IP address from the DHCP server or assigns one to itself.
While the network configuration mode is active, the configuration WiFi is available in the immediate
vicinity of the device (only for devices with WiFi antenna).
The name and password of the WiFi is behnke-station. If you are connected to the WiFi, open your
browser and enter http://behnkestation or alternatively the IP address 10.10.10.10 in the address
bar.
The network configuration mode is automatically terminated after 10 minutes or after changing the
network configuration.
Language
71 2 # German
3 # French
4 # English
Here you can set the language used for voice outputs and display outputs.
Operating mode
72 0 # Analogue phone
1 # SIP phone
2 # IP intercom station
The device can be operated as an analogue phone, as a SIP phone or as an IP intercom station.
Analogue phone
Operating mode, if the device is connected to an analogue phone line
www.behnke-online.de
Commissioning and Configuration
Default: 0
Default: 4
Default: 1
GB
87