2. SETTING UP THE HARDWARE
The first thing to do when you unbox the AudioFuse 16Rig is to set it up for rackmount or
tabletop use. Follow these instructions carefully so you don't damage your interface.
2.1. What's in the box?
•
The AudioFuse 16Rig
•
Rack/stand ears and rear supports with screws
•
Power supply with adapters for worldwide use
•
USB cable: USB-C to USB-C
•
USB cable: USB-C to USB-A
•
Registration card with serial number and Unlock Code
•
Quick Start Guide
2.2. Mounting the hardware: tabletop or rackmount?
The two bright orange rack ears can be attached to the sides of the AudioFuse 16Rig to either
put it in a rack or place it on a desk or table. The screw holes are drilled so as to help you
avoid putting the ears on the wrong sides, but you should still be careful. Just remember
that the left ear has the Arturia logo on it!
The unit comes with mounting screws especially chosen for this purpose. Don't use other screws,
and carefully follow the directions in this manual, which match the ones printed on the inside of the box
lid. You don't want your new interface to sit all wobbly on your table, do you?
IMPORTANT: Note that the hole spacing is different between the left and right rackmount ears.
Therefore, please make sure that the Arturia "A" logo is on the left side of the interface.
Arturia - User Manual AudioFuse 16Rig - Setting Up The Hardware
5