Connecting The Leak Sensor; Connecting The Eluent Bottle - Metrohm 930 Compact IC Flex ChS Manual

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3.4.2

Connecting the leak sensor

3.5

Connecting the eluent bottle

Accessories
930 Compact IC Flex ChS (2.930.1200)
Route the loose end into a waste container.
Plugging in the leak sensor connection cable
The leak sensor connection cable is coiled up in the base tray.
1 Pull the leak sensor connection cable out of the base tray as far as
needed.
2 Plug the plug for the leak sensor connection cable into the leak sen-
sor connection socket (labeled Leak Sensor).
The eluent is aspirated out of the eluent bottle via the eluent aspiration
tubing . The eluent aspiration tubing is installed on the entry to the high-
pressure pump.
The tubing must be be fed out of the instrument through a suitable open-
ing (see "Openings on the back panel", page 11) before the loose end
can be connected to the eluent bottle.
For this step, you need the following accessories:
These parts are part of the accessory kit Vario/Flex ONE (6.5000.010).
Eluent bottle (6.1608.070)
￭
3 Installation
￭￭￭￭￭￭￭￭
19