Upright SL26SL Service Manual page 6

I
NTRODUCTION
1.1 I
NTRODUCTION
1.2 G D
ENERAL
DO NOT use the work platform without guardrails properly assembled and in
place.
1-1
P
URPOSE
The purpose of this service and parts manual is to provide instructions and illustrations for the
operation and maintenance of this work platform manufactured by UpRight.
S
COPE
The manual includes procedures for proper operation, maintenance, adjustment, and repair of
this product as well as recommended maintenance schedules and troubleshooting.
ESCRIPTION
The work platform consists of the platform, controller, elevating assembly, power module, control
module, and chassis.
W A R N I N G
!
P
LATFORM
The platform has a reinforced steel
floor, 1.1m (43.5 inch) high guardrails
with midrail, 152 mm (6 inch ) toe-
boards, and an entry gate at the rear of
the platform. The guardrails can be
folded down for access through doors or
for shipment.
P C
LATFORM ONTROLLER
The platform controller contains the
controls to operate the machine. It is
located at the front of the platform cage.
A complete explanation of control func-
tions can be found in Section 2.
E A
LEVATING SSEMBLY
The platform is raised and lowered by
the elevating assembly. The hydraulic
pump, driven by the engine, powers the cylinder. Solenoid operated valves control raising and
lowering.
SL26/30SL Service & Parts
!
Figure 1-1: SL26/30SL Work Platform
1.Platform
2.Platform Controller Assembly
3.Elevating Assembly
4.Power Module
5.Control Module
6.Chassis
3
6
5
2
1
4