Upright SL26SL Service Manual page 48

Service and Repair
Disassembly
1. Unscrew the head cap from the cylinder barrel.
2. Remove the piston and rod assembly from the cylinder barrel.
3. Unscrew the piston nut and remove piston and head cap from the piston rod.
4. Remove the piston static O-ring from the cylinder rod and discard.
5. Remove the piston seal from the piston and discard.
6. Remove the static O-ring, rod seal and rod wiper.
7. Remove the rod end breather.
8. Do not remove the velocity fuse unless replacement is necessary.
Cleaning and Inspection
1. Clean all the metal parts in cleaning solvent and blow dry with filtered compressed air.
2. Check the working surfaces of the piston head cap, cylinder barrel and rod for excessive wear or scoring.
3. Replace parts found to be unserviceable.
4. Replace all seals, O-rings and wipers.
Reassembly
1. Lubricate the static O-ring, rod seal and rod wiper and then install in the head cap.
2. Install the piston seal on the piston.
3. Install the head cap, piston static seal, piston and piston nut on the cylinder rod. Torque nut to 96 Nm (70 ft.
lbs.).
Note: The head cap should be installed from the piston end of the cylinder rod. Sliding the head cap
over the pivot pin hole may damage the rod seal and rod wiper.
3-22
15
14
12
10
16
13
7
8
9
1. Cylinder Barrel
2. Velocity Fuse
3. Fitting, Adapter
4. Hose Assembly
5. Breather
6. Piston Nut
7. Piston Seal
8. Piston
9. Piston Static O-ring
Figure 0-6: Lift Cylinder Assembly
10
11
1
2
3
17
4
6
5
10. Static O-ring
11. Head Cap
12. Cylinder Rod
13. Set Screw
14. Rod Wiper
15. Rod Seal
16. Nut
17. Hose Assembly