Upright SL26SL Service Manual page 27

S
ER VICE AND
0.1 I
NTRODUCTION
W A R N I N G
!
Be sure to read, understand and follow all infor-
mation in the Operation Section of this manual
before attempting to operate or perform service
on any SL26/30SL work platform.
This section contains instructions for the mainte-
nance of the SL26/30SL Work Platform. Procedures
for the operation inspection, adjustment, scheduled
maintenance, and repair/removal are included.
Referring to Section 2 will aid in understanding the
operation and function of the various components
and systems of the SL26/30SL work platform, and
help in diagnosing and repair of the machine.
Refer to "Preventative Maintenance Check list" on
page -2 for recommended maintenance intervals.
Note: Unless otherwise specified, torque all fit-
tings according to "Torque Specifications for
Fasteners" on page -24, and "Torque Specifi-
cations for Hydraulic Components" on
page -24.
0.2 S T
PECIAL OOLS
The following is a list of special tools which may be
required to perform certain maintenance procedures
on the work platform.
• 0-600 PSI (0-41 bar) Hydraulic Pressure Gauge
(p/n 014124-006)
• 0-3000 PSI (0-207) Hydraulic Pressure Gauge
(p/n 014124-030)
• Inclinometer (p/n 010119-000)
• Tilt Sensor Adjustment Tool (p/n 030622-000)
• Quick Disconnect Gauge Port (p/n 063965-002)
0.3 P
REVENTATIVE
(T
ABLE
!
The Complete inspection consists of periodic visual
and operational checks, together with all necessary
minor adjustments to assure proper performance.
Daily inspection will prevent abnormal wear and pro-
long the life of all systems. The inspection and main-
tenance schedule is to be performed at regular
intervals. Inspection and maintenance shall be per-
formed by personnel who are trained and familiar
with mechanical and electrical procedures.
W A R N I N G
!
Before performing preventative maintenance,
familiarize yourself with the operation of the
machine.
Always block the elevating assembly whenever
it is necessary to enter the scissor assembly to
perform maintenance while the platform is ele-
vated. (Figure 0-1, Page 4)
The preventative maintenance table has been
designed to be used primarily for machine service
and maintenance repair. Please photocopy the fol-
lowing page and use this table as a checklist when
inspecting the machine for service.
Section 3
R
EPAIR
M
AINTENANCE
3-1)
!
3-1