Assembly Instructions; Figure 2 Crank Assembly; Figure 3 Center Head Assembly; Figure 4 Knife Assembly - Univex MP-100 Operator's Manual

Assemble the MP-100 Perfect Peeler in the following order:
1. Attach the support with the two side heads to the under side of the top plate with the two knobs.
2. Assemble the small gear and shaft through one spacer and the pillow block then the other spacer
and into the handle assembly and secure it with the release pin. Refer to the crank assembly
figure 2.
3. Slide the center head with the large gear onto the center head shaft. Place this assembly into the
peeler meshing the gear teeth and placing the square ends of the shaft under the shaft supports.
Secure the assembly to the shaft supports with the release pins. Refer to the center head assembly
figure 3
4. Place the knife assembly under the top plate and onto the studs and install and tighten the knobs
securely. Be sure to place each side head in the appropriate knife assembly slot. Refer to figure 4.
5. Insure all parts are secure and the center head rotates freely when the handle is turned.
WARNING: The knife and center head pins are sharp and can cut fingers.
PILLOW BLOCK
CENTER HEAD ASSEMBLY
FIGURE 3
CENTER HEAD
AND GEAR ASSEMBLY
RELEASE PIN
SHAFT SUPPORT
RELEASE PIN
SHAFT SUPPORT

ASSEMBLY INSTRUCTIONS

CRANK ASSEMBLY
FIGURE 2
SMALL GEAR
SPACER
SPACER
CENTER HEAD SHAFT
Page 4
RELEASE PIN
HANDLE ASSEMBLY
KNIFE ASSEMBLY
FIGURE 4
SLOTS
RIGHT SIDE HEAD
KNIFE ASSEMBLY
LEFT SIDE HEAD
KNOBS