Changing A Ctcss Tone - Uniden BC895XLT User Manual

4. If a CTCSS tone is found, the tone begins
flashing in the display.
e
5. Press to program the tone with the
frequency stored in the channel.
— or —
Send the frequency with its associated
tone to another channel.
For information about sending a
frequency to another channel, see
Transferring a Programmed Frequency
on page 18.
6. Repeat Steps 2 – 4 to search for tones
associated with other frequencies in the
search range you set in Step 1.
If you want to program tones for several frequencies during your search, follow these steps:
After you program a frequency and a CTCSS tone into a channel, the CTCSS Tone Search
Mode is canceled. To activate the CTCSS Tone Search Mode again, press and hold
until you hear two short beeps.
If you decide to cancel the CTCSS Tone Search Mode while you are searching for
frequencies, press and hold
turns off.

Changing a CTCSS Tone

K
1. Press to activate the CTCSS mode.
2. Select the channel you want to change.
e
3. Press .
The CTCSS tone begins flashing.
K
until you hear two short beeps and the CTCSS indicator
36
K