Searching For Ctcss Tones - Uniden BC895XLT User Manual

Searching for CTCSS Tones

You can use the CTCSS Tone Search Mode to determine if the frequencies in your area are
broadcast with associated tones. You may find frequencies which do not have a tone associated
with them. This may be because CTCSS tones are not being transmitted or because digital
encoded tones, sometimes called DCS, are used and your scanner does not recognize these.
Using CTCSS Tone Search While Scanning
s
1. Press .
2. To determine if a stored frequency has an
associated CTCSS tone, press
when your scanner stops on a channel.
3. Press and hold
short beeps.
CTCSS displays and begins flashing, and
the scanner starts searching for an
associated CTCSS tone. All 38 tones are
checked if the transmission is long
enough. If there is a break before a tone
is identified, then your scanner starts
searching where it left off when the
transmission begins again.
If a CTCSS tone is found, the tone begins
flashing in the display.
e
4. Press to program the tone with the
frequency stored in the channel.
5. Repeat Steps 1 – 4 to search for tones
associated with other stored frequencies.
m
K
until you hear two
SCAN MANUAL
PRI TRUNK DATA
L/O DELAY CTCSS
34
1 2 3
4 6
5
9
7 8
E
0