Selecting a Preset Fleet Map
1.
Select the Trunking Programming mode
and the bank you want to change.
d
2.
Press
.
h
3.
Use
or
d
4.
Press
.
h
5.
Use
or
you want. For example, E1P2 .
e
6.
Press
.
The scanner exits the Trunking
Programming mode, acquires the data
channel, and begins searching using the
preset map you chose.
Note: You will now begin to see Type I Fleet-Subfleet IDs. For example, 100-12, 100-9,
000-12, 400-8, etc. See User Defined Fleet Maps in the Appendix for more information
about Type I IDs.
How do you know if the preset map is correct? You'll have to listen to see if you're following
complete conversations. If not, you should try another preset map.
Programming a Fleet Map
You may want to read User Defined Fleet Maps in the Appendix before programming a fleet map. It
contains a detailed explanation of Scanner Fleet Map Programming, as well as a table listing the
Fleet Map Size Codes.
1.
Select the Trunking Programming mode
and the bank you want to change.
i
to choose E1 .
i
to choose the map
49