Set Lcd Contrast; Set Brightness; Set Beep Tone; Diagnostic Menus - Uniden BC-880FM Owner's Manual

5. Press MENU/OK to select that color. COLOR displays.
6. Repeat these procedures to set the NIGHT backlight color.

Set LCD Contrast

1. Press MENU/OK to activate the menus. Turn Channel Selector
until CONT displays.
2. Press MENU/OK. Turn Channel Selector until DAY displays.
3. Press MENU/OK. DAY blinks.
4. Turn Channel Selector to cycle through the contrast options.
(Lowest = 00; Highest = 15)
5. Press MENU/OK to select the one you want. CONT displays again.
6. Repeat these procedures to set the NIGHT contrast level.

Set Brightness

1. Press MENU/OK to activate the menus. Turn Channel Selector
until BRIGHT displays.
2. Press MENU/OK. DAY displays.
3. Press MENU/OK. DAY blinks.
4. Turn Channel Selector to cycle through the brightness options.
(Lowest = 00; Highest = 15)
5. Press MENU/OK to select the one you want. BRIGHT displays
again.
6. Repeat these procedures to set the NIGHT brightness level.

Set Beep Tone

1. Press MENU/OK to activate the menus. Turn Channel Selector
until BEEP displays.
2. Press MENU/OK. The current setting, ON or OFF, displays.
Turn the Channel Indicator to select ON or OFF.
3.
4. Press MENU/OK to accept the setting; BEEP displays again.
NOTE: WX Alert tone sounds even if Beep tone is turned off.

Diagnostic Menus

1. Press MENU/OK to activate the menus.
2. Turn Channel Selector until DIAG displays.
3. Press MENU/OK to enter the DIAG level.
15