2.4
Installing a 2.5" SATA HDD
You can attach two enhanced Serial Advanced Technology Attachment (SATA) hard
disk drives to IPPC-6192A's internal controller which uses PCI local bus interface.
The following instructions are for installation:
1.
Unscrew the back cover and open it.
2.
Remove four screws and take off HDD bracket.
3.
Insert the HDD into the bracket (see figure )
4.
Put the HDD bracket into the Chassis and fasten the four screws.
5.
Then attach the HDD flat cable and power cable.
6.
Close the rear cover
IPPC-6192A User Manual
12