2.4
Installing a 2.5" SATA HDD
You can attach two enhanced Serial Advanced Technology Attachment (SATA) hard
disk drives to IPPC-6152A's internal controller which uses PCI local bus interface.
The following instructions are for installation:
1.
Unscrew the back cover and open it.
2.
Remove four screws and take off HDD bracket.
3.
Insert the HDD into the bracket (see figure).
4.
Put the HDD bracket into the Chassis and fasten the four screws.
5.
Then attach the HDD flat cable and power cable.
6.
Close the rear cover.
2.5
Installing Add-on Cards
2.5.1
Add-on Cards Support
This system supports two PCI expansion cards.
2.5.2
Installing Add-on Cards
The following procedures will instruct you to install the PCIe riser card provided in the
accessory box.
1.
Detach the five screws on the back to open the lid.
IPPC-6152A User Manual
12