3.1 Introduction
Advantech's UTC series systems are PC-based computers housed in an aluminum enclosure. To perform
system maintenance or hardware upgrades, such as installing an HDD, DRAM, or CompactFlash (A/B models
only), simply remove the unit's rear cover.
Warning! Do not remove the rear cover until you have verified that power is not flowing within the
device. The system power should be switched off and the power cord unplugged before opening the
device enclosure.
3.2 Installing a 2.5" SATA HDD/SSD(For UTC-220/232)
UTC systems feature a 2.5" SATA HDD bay reserved for customizable storage. To install a 2.5"
SATA HDD, follow the steps below.
Insert the SATA HDD into the metal bracket and fasten in place with screws.
Use a power cable to connect the SATA HDD to the power supply unit.
Use a SATA data cable to connect the SATA HDD to the motherboard.
Replace the rear cover and tighten the screws.
UTC-220
UTC-232
34