Installation In Multiple Combinations - HomeMatic HMIP-WTH Mounting Instruction And Operating Manual

The bore holes (Q) can be used for installation
with a flush-mounting box.
• Now drill the bore holes.
If you are working with a stone wall, drill the
marked 5 mm holes and insert the plugs supplied.
If you are working with a wooden wall, you can
pre-drill 1.5 mm holes to make screws easier to
insert.
• Use the supplied screws and plugs (R) to fasten
the mounting plate to the wall (see figure 5).
• Attach the clip-on frame (A) to the mounting
plate.
• Place the electronic unit (B) back into the frame
(see figure 1). Make sure that "TOP" and the ar-
rows on the back side point upwards and that the
clips on the mounting plate latch into the open-
ings on the electronic unit.
5.2.3

Installation in multiple combinations

You can mount the wall thermostat with the attachment
frame (A) provided or use it with frames of other manu-
facturers as well as integrate the electronic unit (B) into
a multi-gang frame. You can flexibly fix the mounting
plate (F) to the wall using adhesive strips or screws. For
mounting with multiple combinations, make sure that the
Start-up
33