HOP-SPORT ULTIMA PRO HS-4500LB Instruction Manual page 77

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 61
GB Troubleshooting
Error Code
Probable cause
E01
Comunication error. Computer wires
and lower control plate wires don't
connect correctly.
E02
Anti-bumper protection. Input voltage
value is lower than needed.
E03
Speed sensor signal is not received
by control panel.
E04
Treadmill gradient mechanism does
not work.
Gradient engine is damaged or gradient
engine wire isn't plugged correctly or
is damaged.
E05
Overload protection. Voltage is too low
or too high.
Control module is damaged.
E07
Computer does not display the data.
GB Technical parametres
Possible solution
1. Check if the computer wires and lower control plate wires are connected correctly.
2. Make sure that IC in lower control plate was put correctly. If not, take it out
3. If the power of lower control plate is incorrect, change it for a new one.
1. Check if the voltage power value is proper. If it is lower, change the voltage
2. Check the wires connection to the engine.
3. Check the control panel, in case of need replace it.
1. If the speed sensor is not working, check if the signal light is on. If not, it may
2. Check if the speed sensor plug is plugged correctly. If not, unplug it and
3. Check if the magnetic sensor is not damaged. If you think that there is any
1. Check if the gradient engine wire is plugged correctly. Connection should
2. Check if any wire is damaged or broken.
3. Damaged gradient wire or bracket should be replaced with a new one.
1. Check the voltage. Change for the required one for treadmill to work.
2. The belt encounter resistance. Lube it in accordance with the guidance in
3. Check the engine work, in case of damage – replace it.
Replace the control panel.
Power
Maximum power
Netto weight
Speed range
and put in again.
to the required to start the treadmill and reset the device.
mean that the sensor is damaged. Replace it with a new one.
plug it again.
damage, replace it with a new one.
be in accordance to the symbol on control plate.
the present instruction.
According to the indication on device
According to the indication on the device
~87 kg
0,8–22,0 km/h
73

Advertisement

Table of Contents
loading

Table of Contents