Table of Contents
Advertisement
6
Operation Kalfire Gi
6.1
Operation options
Operation of the fireplace can be done using
either the Kalfire remote control or the Kalfire
Connected app. The Kalfire Connected app
offers more and more extensive operating
options. This app can be downloaded for free in
the Apple and Android app store respectively.
The remote control is supplied with the fireplace
as standard.
6.1.1 Placing the battery
Insert the supplied battery into the remote
control.
Grasp the remote control on-the-head and
•
turn it over.
Place your thumb as shown below.
•
Press the back lightly with your thumb and
•
slide the cover upwards at the same time.
Figure 23: placing the battery
Insert the battery (1 x AAA)
•
Replace the cover in reverse order.
•
CAREFUL!
The remote control contains a temperature
sensor and should be in the room where the
fireplace is located at all times, even if you only
operate the fireplace via the app. The remote
control must be paired with the fireplace.
6.2
Pairing the remote control
The remote control must be paired with the
fireplace. Pairing is done at the factory. If
batteries are inserted in the remote control,
automatic pairing takes place.
If automatic pairing does not take place, proceed
as follows:
You easily check whether the fireplace is paired
by operating button 8 EmberGlow of the remote
control (see image below). If the glow bed in the
fireplace lights up (even when the fireplace is not
lit), the remote control is paired. With each press
of the button, the glow bed's light intensity
increases.
If the remote control is not paired, follow the
instruction below.
Pairing:
To pair the remote control with the fireplace,
both the communication board and the remote
control must be activated.
The green LED light on the communication
•
board flashes.
Briefly (2-5 sec), until the KalSense ring turns
•
blue) press the reset button on the
communication board. The communication
board is located at the front of the fireplace
and can be reached through the 7mm air
gap (also after installation). Use a
plastic/wood (not iron!) stick with a blunt
tip.
Figure 24: position reset button / LED-lights
Then (within 30 seconds), press the key
•
combination below on the remote control to
activate the handheld mode.
Pairing remote control on
The red LED-light on the left top of the
remote control starts to blink.
Release the keys.
•
If the green LED light on the communication
board is continuously lit and the KalSense
ring flashes blue, the remote control has
been successfully paired.
23
Advertisement
Table of Contents
