Mounting Bolt Dimensions (Csu Models); Operation; General - Hatco CSU Series Installation And Operating Manual

INSTALLATION
Mounting Bolt Dimensions — CSU Models
Bolt Hole
Model Location (A)
677 mm
CSU-24-F
(26-11/16")
677 mm
CSU-24-I
(26-11/16")
677 mm
CSU-24-S
(26-11/16")
982 mm
CSU-36-F
(38-11/16")
982 mm
CSU-36-I
(38-11/16")
982 mm
CSU-36-S
(38-11/16")
1287 mm
CSU-48-F
(50-11/16")
1287 mm
CSU-48-I
(50-11/16")
1287 mm
CSU-48-S
(50-11/16")
C
Mounting brackets shown for hole location reference. Holes must be
pre-drilled on underside of countertop where brackets will be mounted.

OPERATION

General

Use the following procedures to operate a Cold Built-In Shelf.
WARNING
Read all safety messages in the Important Safety
Information section before operating this equipment.
Make sure food product has been chilled to the proper
food-safe temperature before placing in the unit. Failure
to chill food product properly may result in serious health
risks. This unit is for holding pre-chilled food product only.
This unit is for holding food for short periods of time.
Never hold food longer than 4 hours.
Bolt Hole Bolt Hole
Location (B) Location (C)
541 mm 462 mm
(21-5/16") (18-3/16")
541 mm 563 mm
(21-5/16") (22-3/16")
541 mm 677 mm
(21-5/16") (26-11/16")
845 mm 462 mm
(33-5/16") (18-3/16")
845 mm 563 mm
(33-5/16") (22-3/16")
845 mm 677 mm
(33-5/16") (26-11/16")
1150 mm 462 mm
(45-5/16") (18-3/16")
1150 mm 563 mm
(45-5/16") (22-3/16")
1150 mm 677 mm
(45-5/16") (26-11/16")
A
Unit Outline
B
Bolt Hole
Location (D)
325 mm
(12-13/16")
426 mm
(16-13/16")
541 mm
(21-5/16")
325 mm
(12-13/16")
426 mm
(16-13/16")
541 mm
(21-5/16")
325 mm
(12-13/16")
426 mm
(16-13/16")
541 mm
(21-5/16")
D
This unit is designed for use in environments where ambient
temperature is between 18°C (65°F) and 30°C (86°F).
When shipped during cold weather months, store unit in
proper ambient temperature environment for 10 hours to
prevent compressor and/or refrigerant line damage. If unit
is turned on and there is excessive noise and vibration,
turn off immediately and allow additional warm up time.
18
English
NOTICE
Form No. CS_AAM-0417