Table of Contents
Advertisement
Figure 78. Installing system board
Next steps
1. Replace the following:
a.
Trusted Platform Module
b.
Internal Perc card
c.
Expansion card
riser.
d. Processor(if removed).
e. Heatsink(if removed).
f.
Memory
modules(if installed).
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3.
Install the air
shroud.
4.
Install the system
cover.
5. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature
section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). See the
6. Follow the procedure listed in
Restoring the system using Easy Restore
The Easy Restore feature enables you to restore your service tag, license, UEFI configuration, and the system configuration data
after replacing the system board. All data is backed up in a backup flash device automatically. If BIOS detects a new system
board, and the service tag in the backup flash device, BIOS prompts the user to restore the backup information.
(TPM).
or
Front PERC
riser.
by using System Setup section.
After working inside your
Restoring the system by using the Easy Restore
Upgrading the Trusted Platform Module
system.
Installing and removing system components
Manually
section.
105
Advertisement
Table of Contents
