Processor Settings; Sata Settings - Dell PowerEdge R360 Installation And Service Manual

Table 33. Memory Settings details (continued)
Option
Current State of Memory Operating Mode
Memory training
DIMM Population

Processor Settings

To view the Processor Settings screen, power on the system, press F2, and click System Setup Main Menu > System
BIOS > Processor Settings.

SATA Settings

To view the SATA Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
SATA Settings.
Table 34. SATA Settings details
Option
Embedded SATA
Security Freeze Lock
Write Cache
Port n
Table 35. Port n
Options
Model
Drive Type
Description
hypervisors for host virtualization resilience. Specify the FRM percentage
by using the Fault Resilient Mode Memory Size[%] feature.
Specifies the current state of the memory operating mode.
When option is set to Fast and memory configuration is not changed,
the system uses previously saved memory training parameters to train
the memory subsystems and system boot time is also reduced. If memory
configuration is changed, the system automatically enables Retrain at
Next boot to force one-time full memory training steps, and then go back
to Fast afterward.
When option is set to Retrain at Next boot, the system performs the
force one-time full memory training steps at next power on and boot time
is slowed on next boot.
When option is set to Enable, the system performs the force full
memory training steps on every power on and boot time is slowed on
every boot.
Provides information about the DIMM slots which has an installed DIMM.
Description
Enables the embedded SATA option to be set to Off, AHCI mode , or RAID modes.
This option is set to AHCI Mode by default.
NOTE:
1. You might also need to change the Boot Mode setting to UEFI. Otherwise, you
should set the field to Non-RAID mode.
2. No ESXi and Ubuntu OS support under RAID mode.
Sends Security Freeze Lock command to the embedded SATA drives during POST.
This option is applicable only for AHCI Mode. This option is set to Enabled by default.
Enables or disables the command for the embedded SATA drives during POST. This
option is applicable only for AHCI Mode. This option is set to Disabled by default.
Sets the drive type of the selected device.
For AHCI Mode, BIOS support is always enabled.
Descriptions
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Pre-operating system management applications 33