Installing The Boss N1 Module - Dell PowerEdge R360 Installation And Service Manual

Figure 57. Removing the BOSS N1 card
Next steps
1. Install the BOSS N1 module

Installing the BOSS N1 module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove system cover.
4. Remove air shroud.
5. Remove the BOSS N1
Steps
1. Insert the BOSS N1 card in to the cage.
2. Tighten the two screws to secure the BOSS N1 card to the cage.
88 Installing and removing system components
or Install the BOSS N1
Safety
Before working inside your
blank.
blank.
instructions.
system.