Dell PowerEdge R360 Installation And Service Manual page 40

Table 46. System Security details
Option
CPU AES-NI
System Password
Setup Password
Password Status
TPM Information
Table 47. TPM 2.0 security information
Option Description
TPM Information
TPM
NOTE:
Security
Enables you to control the reporting mode of the TPM. When set to Off, the presence of the TPM is not
reported to the OS. When set to On, the presence of the TPM is reported to the OS. The TPM Security option
is set to Off by default.
When TPM 2.0 is installed, the TPM Security option is set to On or Off. This option is set to Off by default.
TPM Indicates the type of Trusted Platform Module, if present.
Informatio
n
TPM Indicates the firmware version of the TPM.
Firmware
TPM Enables, disables, or clears the storage and endorsement hierarchies. When set to Enabled, the storage and
Hierarcy endorsement hierarchies can be used.
When set to Disabled, the storage and endorsement hierarchies cannot be used.
When set to Clear, the storage and endorsement hierarchies are cleared of any values, and then reset to
Enabled.
TPM TPM PPI
Advanced Bypass
Settings Provision
TPM PPI
Bypass Clear
TPM2
Algorithm
Selection
Table 48. System Security details
Option
Power button:
40 Pre-operating system management applications
Description
Improves the speed of applications by performing encryption and decryption by using
the Advanced Encryption Standard Instruction Set (AES-NI). This option is set to
Enabled by default.
Sets the system password. This option is set to Enabled by default and is read-only if
the password jumper is not installed in the system.
Sets the setup password. This option is read-only if the password jumper is not installed
in the system.
Locks the system password. This option is set to Unlocked by default.
Indicates the type of Trusted Platform Module, if present.
The TPM menu is available only when the TPM module is installed.
When set to Enabled, allows the Operating System to bypass Physical Presence Interface
(PPI) prompts when issuing PPI Advanced Configuration and Power interface (ACPI)
provisioning operations.
When set to Enabled allows the Operating System to bypass Physical Presence Interface
(PPI) prompts when issuing PPI Advanced Configuration and Power Interface (ACPI) clear
operations.
Allows the user to change the cryptographic algorithms used in the Trusted Platform Module
(TPM). The available options are dependent on the TPM firmware.
To enable TPM2 Algorithm Selection, Intel(R) TXT technology must be disabled.
The TPM2 Algorithm Selection option supports SHA1, SHA128, SHA256, SHA512 and SM3 by
detecting the TPM module. This option is set to
SHA1 by default.
Description
Enables or disables the power button on the front of the system. This option is set to
Enabled by default.