Figure 23. Installing the intrusion switch
3. Connect the intrusion switch cable to the connector on the system board.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Drive backplane
This is a service technician replaceable part only.
Drive backplane guidelines
Depending on your system configuration, the drive backplanes supported in PowerEdge R360 are listed here:
Table 55. Supported backplane options for PowerEdge R360 system
System
PowerEdge R360
After working inside your
system.
Supported backplane options
2.5-inch (x8) SAS/SATA/SSD backplane
3.5-inch (x4) SAS/SATA/SSD backplane
Installing and removing system components
59