Advertisement
"l can't record from my TW'
"l can't timer record/'
When the VCR is in VCR mode and your TV is set
to channel 3 or 4, you should be able to view the
desired channel
on your TV. If you have a cable
converter
box, make sure the VCR is tuned to the
cable converter
box output channel.
Make sure that your Dual-Deck
VCR's clock is set to
the proper time. Double check the AM/PM setting.
If
you have a cable converter
box, make sure the timer
record channel
setting in the TIMER RECORD menu
is set to the cable converter
box output channel
(2, 3
or 4) and the cable box is set to the channel you want
to record.
"My remote ¢ontrN
isn't worRing."
There are several things which could cause yore
remote control not to function properly. First, make
sure you are aiming the remote control directly at the
VCR. Make stlre there are no obstacles between the
remote control and the VCR so the 'beam' is not
obstructed. Also, the
signal
fl'Oil* the remote can be
obstructed if a very strong light source, such as
sunlight,
falls on the front panel of the VCR. Finally,
make sure the batteries
in yore remote control are
fresh and installed
properi>
"When 1use Cepy Tape, my tapes are reeerded at
a speed ether than what was set."
In the COPY TAPE menu, check to see if Speed
Matching
is on. When this feature
is on, the recording
speed of a copy will be set to the speed of the somce
tape. If you want to change the speed at which the
tape is being copied, turn this _eature off.
"When 1 use ¢epy Tape er put a tape
inte reeerd, the tape ejects."
Make sure there is a Record Safety Tab on your tape.
If the tab is
missing,
yolJ can place a small piece of
transparent
tape over the hole. This will allow you to
copy or record onto the tape.
64
DISCOVERTHE DUAL-DECKDIFFERENCE
Advertisement
