Advertisement
OTR
PAUSE
PLAY
POWER
RECORD
SAFETY
TAB
REW
SAP
SLOW
SP, LP, EP
One _fbuch Recording.
Each time you press REC after
the first time, yotJ add 30 minutes
to the record time.
For Loop Recording
on the same tape (see page 22),
press tmtil you see 9 rain. 30 sec. on fiont panel
display; then press once more.
Press this button to temporarily
stop a tape while
playing
(still) or recording
(pause). It you leave Pause
on fl)r 5 minutes,
the VCR will automatically
begin to
play to prevent
tape damage.
Press to play the tape in the active deck. Press and
hold 1.5 seconds for ATR.
Press on either the remote control or the Dont panel
of the VCR to turn your Dual-Deck
VCR on and off,
The indicator
light is on when the VCR is on and off
when the VCR is off. If the POWER key is pressed
while timer recording,
copying a tape or rewinding,
the power light will blink. This indicates
that the VCR
is in a power-off mode and that when the current
ftmc-
tion is complete, the VCR will automatically
turn off.
VHS tapes have a record saDty tabs to protect you
fiom accidentally
recording
over your tapes. You
break this tab off to prohibit
recording.
If you later
wish to record on that tape, you can put a small piece
of tape over the opening.
Press this button on the remote control while the
active deck is stopped to rewind the tape. Press while
the tape is playing to rewind while viewing the
picture.
Press again while a tape is playing to speed
up picture rewind.
Secondary
Audio Program.
This indicator
on the fiont
panel will be on if the TV program
being broadcast
has a Secondary
Audio Program
signal. This audio
can be selected via the tuner
audio selection
in the
Tuner Setup menu.
You can start
a tape in Deck One and when it finishes
playing,
a tape in Deck Two will automatically
play.
See Playback
Mode in the Features
menu.
Pressing
these buttons
slows the speed the tape is
playing.
Successive
pressing
of the _]
key on the
remote control steps tip the speed of the tape. Succes-
sive pressing
of the _,
key on the remote control
slows down the speed of the tape. Press PLAY to
resmne normal speed.
This indicator
on the fiont panel display shows the
tape speed fl_r the selected deck. Ifyou are playing a
tape, the tape speed is the speed at which the tape was
recorded.
If you are recording,
you can set the tape
speed - see Record Speed in the Deck Two menu.
APPENDIX B-GLOSSARY
61
Advertisement
