Troubleshooting; Troubleshooting Machine - Wacker Neuson BPS Series Operator's Manual

Troubleshooting

10.1 Troubleshooting machine

10 Troubleshooting
10.1 Troubleshooting machine
Fault
The engine cannot be started.
Engine does not work.
Engine cannot be switched off.
No vibration when the engine is run-
ning.
* Have this work carried out by a service partner.
44 Operator's Manual | BPS1030B, BPS1135B, BPS1340B, BPS1550B, BPS2050B | BPS | 5100066824 | 04/2023 |
Version: 5 | [en-US]
WARNING
Danger to life due to unauthorized troubleshooting!
► If faults occur on this machine which are not described in this oper-
ator's manual, contact the service partner.
► Do not rectify faults on your own.
Possible cause
Engine switch off.
Throttle lever in stop or idle position. Throttle lever on.
Fuel cock is closed.
Not enough fuel.
Incorrect valve clearance.
Valves worn.
Cylinder and/or piston ring worn.
Spark plugs worn.
Engine oil level too low.
Soiled air filter.
Soiled air filter.
On/off switch is defective.
V-belt worn.
Clutch linings worn out.
Remedy
Engine switch on.
Open the fuel cock.
Refill with fuel. Check fuel filter and
fuel lines.
Check valve clearance, have it ad-
justed if necessary.*
Have the machine repaired.*
Replace spark plug.
Add engine oil.
Clean air filter replace if necessary.
Clean air filter replace if necessary.
Have the machine repaired.*
Change V-belt.
Have the clutch linings replaced.*