Table of Contents
Advertisement
Step 2:
Use a flathead screwdriver and apply a little extra force to detach a knockout tab until it
breaks off from the system.
Once the knockout tab is mostly detached, it will pretty quickly snap off, leaving you a nice
hole for installing an antenna.
Step 3:
Connect the internal cable to the board's antenna connector, screw the antenna connector
through the antenna hole with washers and nuts, and screw on the antenna as illustrated below.
Module Connector
Quick Installation Guide | ED700-EHL22I
Chassis Wall
Cable
Antenna Connector
Antenna
Washer
Nut
9
Advertisement
Table of Contents
