Table of Contents
Advertisement
Stubborn soiling on the
FlexiClip telescopic runners
Do not clean FlexiClip telescopic
runners in a dishwasher. The special
lubricant used in the telescopic
runners will wash out during
dishwashing.
This will affect their smooth
functioning.
For stubborn surface soiling or if the
bearings become sticky, proceed as
follows:
Soak the FlexiClip telescopic runners
briefly (approx. 10 minutes) in a
solution of hot water and
dishwashing liquid.
If necessary, the scouring pad on the
back of a non-scratching
dishwashing sponge can be used to
remove the soiling. You can clean the
bearings with a soft brush.
The runners may appear discoloured
or a lighter colour in places after they
have been cleaned. This will not affect
the functioning of the runners in any
way.
Cleaning and care
Cleaning the catalytic
enamelled back panel
Catalytic enamel is self-cleaning, which
means that soiling from oil and fat is
burnt off automatically when very high
temperatures are reached inside the
oven. You do not need to use any
additional cleaning agent. The higher
the temperature, the more effective the
process.
Exposure to scouring agents,
abrasive brushes or sponges and
oven sprays can cause catalytic
enamel to lose its self-cleaning
properties.
Remove the catalytic enamelled
panels before using an oven cleaner
in the oven compartment.
Removing soiling caused by spices,
sugar and similar deposits
Remove the back panel (see
"Cleaning and care – Removing the
back panel").
Clean the back panel by hand with a
solution of hot water and washing-up
liquid applied with a soft brush.
Rinse the back panel thoroughly.
Let the back panel dry before placing
it back in the oven.
91
Advertisement
Table of Contents
