Answering A Call - Grandstream Networks GAC2500 User Manual

2. Set the mode to "IP Call";
3. Input the target IP address. For example, if the target IP address is 192.168.124.123 and the port is 5062, input the
following:
192*168*124*123#5062
The * key represents the dot (.) and the # key represents the colon (:).
4. Press to dial out.
Notes
In dial pad, default call mode also supports IP call by dialing IP address. GAC2500 would analyze the input and make IP
calls.
Default call mode does not support quick IP call. If you want to make quick IP call, please change the call mode to "IP call".
Paging/Intercom
Before placing paging/intercom, please make sure the callee has paging/intercom enabled so it can automatically answer the
paging/intercom call. To make paging/intercom call:
1. Access the dial screen on GAC2500;
2. Set the mode to "Paging";
3. Enter the number to dial;
4. Press to dial out.

Answering a Call

When the device is in idle and there is an incoming call, the device will show the call screen as below.
Select "Answer" to answer the call, or reject the call by pressing the "Reject" soft key.
When there is an incoming call during an active call, users will hear a call waiting tone with the LCD displaying the caller name
and ID for the incoming call.
Figure 27: GAC2500 Single Incoming Call Screen