Usb Slave Mode - Grandstream Networks GAC2500 User Manual

IP Mode
The GAC2500 is used as an independent phone in IP mode. Please follow the steps below to connect.
1. Connect the LAN port of the device to the external network port (the port in the office or at home) via Ethernet cable;
2. Plug in the power adapter into the power supply interface then power up the GAC2500.
Note
It is recommended to use IP mode in room 3.6m* 7.2m or smaller.

USB Slave Mode

GAC2500 can be used as auxiliary
disabled in USB slave mode. Follow the steps below to connect route.
1. Connect one end of the USB cable to the Micro USB port of the device and the other end to the USB port of GVC3200/PC;
2. Plug in the power adapter into the power supply interface then power up the GAC2500.
The GAC2500 screen is as shown below in USB slave mode.
Call
Tape on the Call icon to see the GVC3200 call screen, users can make Audio/Video calls, share contents, Hold/UnHold, Record,
Enable/Disable DND, and add more users to the conference.
Contacts
Tape on contact and a list of the GVC3200 will show up, users can search, make calls and sync with GVC3200 contacts if a new
entry is added from the GVC3200.
Schedule
Tape on Schedule to view all the scheduled meeting from GVC3200.
PTZ
Tape on PTZ to access the GVC3200 PTZ settings, users could control PTZ movement in camera mode, set presets, zoom
In/Out and adjust the focus.
Figure 4: Connecting the GAC2500
device for GVC3200 or PC for audio acquisition and play. The conference feature will be
Figure 5: GAC2500 Slave Mode Screen