Schenck process Intecont Plus Belt Weigher Operating Manual page 86

VBW
As of version VBW20600-08, the options FIXED-1 and
FIXED-2 in parameter L06, "Configuration", are no
longer available and have been replaced by
FIXED.The values carried over with the setting FIXED
are determined by the following parameters. The
settings of the original values correspond to the
previous FIXED mode 1.A list of all available
identifiers and FIXED mode examples can be found in
the manual BV-H2220.
V 01 ID preset value 1
Range: Fest eingestellt
Command 4+5
V 02 ID preset value 2
Range: 0...4086
Command 6+7
V 03 ID preset value 3
Range: 0...4086
Command 8+9
V 04 ID preset value 4
Range: 0...4086
Rreload setpoint [kg]
V 05 ID preset value 5
Range: 0...4086
Batch setpoint [kg]
V 06 ID preset value 6
Range: 0...4086
Batch number
Parameterization
BV-H2214 GB 82
Block V:
Default: 320
Default: 352
Default: 384
Default: 596
Default: 594
Default: 598
Technische
Redaktion PDE-RD
INTECONT PLUS
Fixmode Parameters
V 07 ID preset value 7
Range: 0...4086
V 08 ID preset value 8
Range: 0...4086
V 09 ID read value 1
Range: 0...4086
Status 2+3
V 10 ID read value 2
Range: 0...4086
Status 4+5
V 11 ID read value 3
Range: 0...4086
Highest priority event
V 12 ID read value 4
Range: 0...4086
Actual flow rate [kg/hr]
V 13 ID read value 5
Range: 0...4086
Totalizing counter 1 [kg]
Default: 0
Default: 0
Default: 752
Default: 784
Default: 1552
Default: 1872
Default: 1874
Transmission to third parties and reproduction of
this documentation are not permitted. Schenck
Process GmbH reserves all rights of ownership
and copyrights.
0837