Dell PowerEdge HS5620 Installation And Service Manual page 52

Table 49. Network Settings details (continued)
Option
ISCSI Initiator Name
ISCSI Device1
ISCSI Device1 Settings
UEFI NVMe-oF Settings
NVMe-oF
NVMe-oF Host NQN
NVMe-oF Host Id
Host Security Key Path
NVMe-oF SubSystem Settings
Table 50. PXE Device n Settings details
Option
Interface
Protocol
VLAN
VLAN ID
VLAN Priority
Table 51. HTTP Device n Settings details
Option
Interface
Protocol
VLAN
VLAN ID
VLAN Priority
DHCP
IP Address
Subnet Mask
52 Pre-operating system management applications
Description
Specifies the name of the iSCSI initiator in IQN format.
Enables or disables the iSCSI device. When disabled, a UEFI boot option
is created for the iSCSI device automatically. This is set to Disabled by
default.
Enables you to control the configuration of the iSCSI device.
Enables you to control the configuration of the NVMe-oF devices.
Enables or disables the NVMe-oF feature. When enabled, it allows to
configure the host and target parameters needed for fabric connection.
This is set to Disabled by default.
This field specifies the name of the NVMe-oF host NQN. Allowed input is
in the following format: nqn.yyyy-mm.<Reserved Domain Name>:<Unique
String>. Leave it empty to use system generated value with following
format: nqn.1988-11.com.dell:<Model name>.<Model number>.<Service
Tag>.
This field specifies a 16 bytes value of the NVMe-oF host identifier
that uniquely identifies this host with the controller in the NVM
subsystem. Allowed input is a hexadecimal-encoded string in this format:
00112233-4455-6677-8899-aabbccddeeff. Leave it empty to use system
generated value. A value of all FF is not allowed.
This field specifies the Host security key path.
This field controls the parameters for the NVMe-oF subsystem n
connections.
Description
Specifies NIC interface used for the PXE device.
Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to
IPv4 by default.
Enables VLAN for PXE device. This option is set to Enabled or Disabled. This option is set to
Disabled by default.
Shows the VLAN ID for the PXE device
Shows the VLAN Priority for the PXE device.
Description
Specifies NIC interface used for the HTTP device.
Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set
to IPv4 by default.
Enables VLAN for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
Shows the VLAN ID for the HTTP device
Shows the VLAN Priority for the HTTP device.
Enables or disables DHCP for this HTTP device. This option is set to Enabled by default.
Specifies IP address for the HTTP device.
Specifies subnet mask for the HTTP device.