Table of Contents
Advertisement
Figure 97. Removing the BOSS-N1 controller card module
6. Remove the BOSS power cable and BOSS signal cable from the BOSS-N1 controller card module.
Figure 98. Removing the BOSS power cable and BOSS signal cable from the BOSS-N1 controller card module
7. Using the Phillips #1 screwdriver, remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS cover on the BOSS-N1
controller card module. Slide the BOSS cover out from the BOSS-N1 controller card module.
134
Installing and removing system components
Advertisement
Table of Contents
