Dell PowerEdge HS5620 Installation And Service Manual page 101

Table 71. Cable routing - 12 x 3.5-inch + 2 x 2.5-inch SAS/SATA backplane and rear drive module with
single, and dual processor configuration (PERC11) (continued)
From
FAN_SIG (Fan signal cable on fan board)
SYS_PWR2 (power connector on system board)
FAN_PWR (power connector on fan board)
SYS_PWR1 (power connector on system board)
SIG_PWR_3 (power connector on PIB)
Figure 62. Cabling diagram of configuration 3 - 12 x 3.5-inch + 2 x 2.5-inch NVMe backplane and rear drive module
with single, and dual processor configuration (PERC11)
Table 72. Cable routing - 12 x 3.5-inch + 2 x 2.5-inch NVMe rear drive module with single, and dual
processor configuration (PERC11)
From
BP_DST_SA1 (signal connector on backplane)
BP_PWR_1 (power connector on backplane)
BP_DST_SB1 (signal connector on backplane)
BP_DST_PA1 (Signal connector on rear drive module)
BP_DST_PB1 (Signal connector on rear drive module)
FAN_SIG (Fan signal cable on fan board)
SYS_PWR2 (power connector on system board)
FAN_PWR (power connector on fan board)
SYS_PWR1 (power connector on system board)
SIG_PWR_3 (power connector on PIB)
To
FAN_SIG_1, FAN_SIG_2 (fan signal cable on system board)
CPU_PWR2 (power connector on PIB)
FAN_PWR1 (power connector on PIB)
SYS_PWR1_1 , SYS_PWR1_2 (power connectors on PIB)
BP_PWR_1 (Power connector on the rear drive module)
To
CTRL_SRC_SA1 (signal connector on PERC adapter)
SIG_PWR_1 (power connector on PIB)
CTRL_SRC_SB1 (signal connector on PERC adapter)
SL5_CPU1_PA3 (signal connector on system board)
FAN_SIG_1, FAN_SIG_2 (fan signal cable on system board)
CPU_PWR2 (power connector on PIB)
FAN_PWR1 (power connector on PIB)
SYS_PWR1_1 , SYS_PWR1_2 (power connectors on PIB)
BP_PWR_1 (Power connector on the rear drive module)
Installing and removing system components 101