Table of Contents
Advertisement
2. Using the system board holder, lower the system board leaning at an angle into the system as shown in the image.
3. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
Figure 128. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
Internal USB key (if installed)
c.
Intrusion switch
d.
Expansion cards
e.
Expansion card risers
f.
Cooling fan cage assembly
g.
Processor
h.
Heat sink
i.
Memory modules
j.
OCP
k.
Air shroud
l.
System cover
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature
section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag by using System Setup
c. Update the BIOS and iDRAC versions.
Re-enable the Trusted Platform Module (TPM). See the
4. If you are not using Easy restore, import your new or existing iDRAC Enterprise license. For more information, see the
Integrated Dell Remote Access Controller User's Guide available at https://www.dell.com/idracmanuals..
5. Follow the procedure listed in
160
Installing and removing system components
section.
After working inside the
system.
Restoring the system by using the Easy Restore
Upgrading the Trusted Platform Module
Manually
section.
Advertisement
Table of Contents
