Gas Feeding; 4.14.1 Gas Feed Connection To The Burner; General Gas Feeding Diagram (Example) - Riello DB 2 LSE FGR Installation, Use And Maintenance Instructions

4.14

Gas feeding

Explosion danger due to fuel leaks in the pres-
ence of a flammable source.
Precautions: avoid knocking, attrition, sparks and
heat.
Make sure the fuel interception tap is closed be-
fore performing any operation on the burner.
The fuel supply line must be installed by qualified
personnel, in compliance with current standards
and laws.
WARNING

4.14.2 General gas feeding diagram (example)

20169526
Key (Fig. 26)
C Vibration damping joint
GF Gas filter
HPG High gas pressure regulator
LPG Low gas pressure regulator
MM Pressure gauge
PA Minimum air pressure switch
PGM Maximum gas pressure switch
PGm Minimum gas pressure switch
RG Gas butterfly valve
SRV Pressure limiting valve with outlet into the environment
VE Fan
VPS Leak detection control device
VR Gas pressure regulator solenoid valve
VS Gas safety solenoid
Installation

4.14.1 Gas feed connection to the burner

Burner connection
The connection of the burner to the gas train is carried out using
the flange connection.
The dimensions of the flange are given in Fig. 2 on page 8.
Use the relative adapters to connect the gas flange to the train,
supplied as accessories.
PARTE A CARICO DELL'INSTALLATORE/UTENTE
23 GB
max. 500 mbar
0,5 ÷ 4 bar
Fig. 26
20169116